the Fly Clone Project

Hey all! I was wondering (it seems like a lot of 13 pin Flys here). In one of the late model flys (with the Graphtech), is installing the Hexpander as easy as making a hole for the jack, plugging the jack into the Hexpander board, and just plugging the Hexpander into the existing piezo board? No routing required of the main cavity? Then adding controls if I decide I want them?

Apologies if this has been covered previously; I couldn’t find info in a search. Thanks!

@mockchoi, In short: Yes. I’ve installed a few Acousti-Phonic/Hexpander setups in Flys; and am happy to answer any other questions you may have to the best of my knowledge.