Rubber Knob

[vjmanzo]

Hey @KenanJ—I’m not sure why the STL for the knob is not in the repo, but I have some people looking into it. I’ll let you know when it turns up.

[KenanJ]

Hey @KenanJ—I’m not sure why the STL for the knob is not in the repo, but I have some people looking into it. I’ll let you know when it turns up.

Ah! Thank you sir ! I will post the iteration I make and share the best result I can get compared to the Davies I have

[ricardomedina]

where can I download this stl to print ? thx a lot !

[KenanJ]

Being as the thread was bumped, I'll mention that I intend to put a set of those Knobeez through their paces in my next Fly project, and share my impressions of whether they live up to the guarantees on the listing page (e.g., that they fit 6mm and 1/4" pot shafts, knurled or smooth, and that they remain secure with push-pull use). However, Roland delaying the release of the gear i intend to use them with means that I can't get to it until some time in this next year.

@mmmguitar just bumping this to confirm that knobeez don’t fit …

[mmmguitar]

@mmmguitar just bumping this to confirm that knobeez don’t fit …

Do they not stay attached to the pot shaft, or do they merely not have the depth to push down as far as the other knobs?

[KenanJ]

@mmmguitar just bumping this to confirm that knobeez don’t fit …

Do they not stay attached to the pot shaft, or do they merely not have the depth to push down as far as the other knobs?

They stay on the shaft but it lacks depth like shown in the picture

[mmmguitar]

They stay on the shaft but it lacks depth like shown in the picture

Thanks. In that case, are there enough threads for the potentiometer nut available to shim the cavity side of the pot shaft with an additional locking washer, to decrease the height of the pot shaft?

I'm referring to these:

[KenanJ]

They stay on the shaft but it lacks depth like shown in the picture

Thanks. In that case, are there enough threads for the potentiometer nut available to shim the cavity side of the pot shaft with an additional locking washer, to decrease the height of the pot shaft?

I'm referring to these:

pot lock washer.jpg

I will check Saturday when I receive 10 strings to try out on my 97 supreme that gives me a hard time getting well setup …

[KenanJ]

@mmmguitar do you have a reference for the wahsers? preferably in a metric value ^^

[mmmguitar]

@mmmguitar do you have a reference for the washers? preferably in a metric value ^^

Those washers (commonly referred to as "locking pot washers" or "star lock washers") generally come in 3/8" (9.525mm) internal diameter. I don't recall if Ken used them in his era of Fly production (can anyone confirm?). In any case, using them to shim the pot shaft height shorter will only work if you have extra, available threads visible past the nut the knob is covering (I'm afraid I don't have a stock '90s Fly to check for myself).

[InsideInfo]

These are all the washers on the prerefine but no star washers except on the input jack.